Commit graph

22 commits

Author SHA1 Message Date
Markus Pargmann
609e6025b8 ASoC: tlv320aic32x4: Fix MICPGA input configuration
Currently the Negative Terminal Input Routing Configuration is only set
when there is a special routing configuration. If we don't use one of
the inputs IN1 or IN2 as negative terminal input, the PGA and recording
does not work.

This patch adds a route from CM1L/CM1R to the PGA as negative input by
default. With this configuration the PGA can amplify all input signals
and line-in/mic works again.

Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
2014-01-27 18:13:44 +00:00
Markus Pargmann
b44aa40f87 ASoC: tlv320aic32x4: Fix mono playback
Playback of a mono stream should output the same stream on both
channels. At the moment only the left analog signal is valid, the right
one is just noise.

This patch maps the left digital channel onto both DACs when receiving a
mono stream.

Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
2014-01-27 18:13:40 +00:00
Markus Pargmann
e8e08c521d ASoC: tlv320aic32x4: Fix regmap range_min
range_min is the lowest address in the virtual register range. This is
the first register with address 0, not the first register of page 1.

Currently all writes to page 1 are mapped to page 0, so the codec fails
to operate.

Fixes: 4d208ca429 (ASoC: tlv320aic32x4: Convert to direct regmap API usage)
Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
Cc: stable@vger.kernel.org (v3.13 if the fix misses -final)
2014-01-15 23:12:44 +00:00
Markus Pargmann
6d0d5103bd ASoC: codec: tlv320aic32x4: Fix regmap range config
This codec driver fails to probe because it has a higher regmap
range_max value than max_register. This patch sets the range_max to the
max_register value as described in the for struct regmap_range_cfg:
"@range_max: Address of the highest register in virtual range."

Fixes: 4d208ca429 (ASoC: tlv320aic32x4: Convert to direct regmap API usage)
Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
Cc: stable@vger.kernel.org (v3.13 if the fix misses -final)
2014-01-13 12:34:51 +00:00
Mark Brown
4d208ca429 ASoC: tlv320aic32x4: Convert to direct regmap API usage
This moves us towards being able to remove the duplicate register I/O
functionality in ASoC and saves some code.

Signed-off-by: Mark Brown <broonie@linaro.org>
2013-09-26 10:58:36 +01:00
Mark Brown
752b776435 ASoC: tlv320aic32x4: Move GPIO acquisition to I2C probe
This is more idiomatic and interacts better with deferred probe.

Signed-off-by: Mark Brown <broonie@linaro.org>
2013-09-26 10:58:35 +01:00
Lars-Peter Clausen
aac97b5fd9 ASoC: tlv320aic32x4: Convert table based control and DAPM setup
Let the core take care of instantiating the controls and DAPM widgets and
routes, this makes the code a bit shorter.

Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
2013-08-27 15:33:34 +01:00
Bill Pemberton
7a79e94e97 ASoC: codecs: remove __dev* attributes
CONFIG_HOTPLUG is going away as an option.  As result the __dev*
markings will be going away.

Remove use of __devinit, __devexit_p, __devinitdata, __devinitconst,
and __devexit.

Signed-off-by: Bill Pemberton <wfp5p@virginia.edu>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-12-10 00:31:51 +09:00
Javier Martin
1858fe97c8 ASoC: tlv320aic32x4: Add rstn gpio to platform data.
Add the possibility to specify a gpio through platform data
so that a HW reset can be issued to the codec.

Signed-off-by: Javier Martin <javier.martin@vista-silicon.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-11-01 14:35:56 +00:00
Javier Martin
a405387c68 ASoC: tlv320aic32x4: Fix problem with first capture.
In its previous status, the first capture didn't work properly;
nothing was actually recorded from the microphone. This
behaviour was observed using a Visstrim M10 board.

In order to solve this BUG a workaround has been added that,
during the initialization process of the codec, powers on and
off the ADC.

The issue seems related to a HW BUG or some behavior that
is not documented in the datasheet.

Signed-off-by: Javier Martin <javier.martin@vista-silicon.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-11-01 14:35:56 +00:00
Sachin Kamat
3b09efd1de ASoC: tlv320aic32x4: Use module_i2c_driver
module_i2c_driver makes the code simpler by eliminating module_init
and module_exit calls.

Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-08-06 15:20:30 +01:00
Liam Girdwood
022658beab ASoC: core: Add support for DAI and machine kcontrols.
Currently ASoC can only add kcontrols using codec and platform component device
handles. It's also desirable to add kcontrols for DAIs (i.e. McBSP) and for
SoC card machine drivers too. This allows the kcontrol to have a direct handle to
the parent ASoC component DAI/SoC Card/Platform/Codec device and hence easily
get it's private data.

This change makes snd_soc_add_controls() static and wraps it in the folowing
calls (card and dai are new) :-

snd_soc_add_card_controls()
snd_soc_add_codec_controls()
snd_soc_add_dai_controls()
snd_soc_add_platform_controls()

This patch also does a lot of small mechanical changes in individual codec drivers
to replace snd_soc_add_controls() with snd_soc_add_codec_controls().

It also updates the McBSP DAI driver to use snd_soc_add_dai_controls().

Finally, it updates the existing machine drivers that register controls to either :-

1) Use snd_soc_add_card_controls() where no direct codec control is required.
2) Use snd_soc_add_codec_controls() where there is direct codec control.

In the case of 1) above we also update the machine drivers to get the correct
component data pointers from the kcontrol (rather than getting the machine pointer
via the codec pointer).

Signed-off-by: Liam Girdwood <lrg@ti.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-02-04 12:40:11 +00:00
Wolfram Sang
0c93a167a6 ASoC: tlv320aic32x4: always enable analouge block
Register LDOCTLEN must always be initialized to clear the analog power
control bit, otherwise the analog block will stay deactivated.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Acked-by: Javier Martin <javier.martin@vista-silicon.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-01-20 13:54:33 +00:00
Wolfram Sang
01b37e94c0 ASoC: tlv320aic32x4: always enable dividers
Dividers (such as MDAC) are always needed, independent of the codec
being I2S master or slave. Needed on a custom board where the codec has
to be slave.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Acked-by: Javier Martin <javier.martin@vista-silicon.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2012-01-20 13:54:33 +00:00
Axel Lin
658ecf7784 ASoC: Convert tlv320aic32x4 to devm_kzalloc()
Signed-off-by: Axel Lin <axel.lin@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-12-28 17:22:41 +00:00
Lars-Peter Clausen
84b315ee89 ASoC: Drop unused state parameter from CODEC suspend callback
The existence of this parameter is purely historical. None of the CODEC drivers
uses it and we always pass in the same value anyway, so it should be safe to
remove it.

Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Acked-by: Liam Girdwood <lrg@ti.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-12-02 10:32:03 +00:00
Mark Brown
997c2ea916 ASoC: Remove unneeded platform_device.h inclusions from CODECs
They've not been needed for a long time if they were ever required.

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-11-27 12:24:48 +00:00
Lars-Peter Clausen
85e7652d89 ASoC: Constify snd_soc_dai_ops structs
Commit 1ee46ebd("ASoC: Make the DAI ops constant in the DAI structure")
introduced the possibility to have constant DAI ops structures, yet this is
barley used in both existing drivers and also new drivers being submitted,
although none of them modifies its DAI ops structure. The later is not
surprising since existing drivers are often used as templates for new drivers.
So this patch just constifies all existing snd_soc_dai_ops structs to eliminate
the issue altogether.

The patch was generated with the following coccinelle semantic patch:
// <smpl>
@@
identifier ops;
@@
-struct snd_soc_dai_ops ops =
+const struct snd_soc_dai_ops ops =
{ ... };
// </smpl>

Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-11-23 10:40:46 +00:00
Axel Lin
bc6ae96a44 ASoC: tlv320aic32x4: Use snd_soc_update_bits for read-modify-write
Use snd_soc_update_bits for read-modify-write register access instead of
open-coding it using snd_soc_read and snd_soc_write.

Signed-off-by: Axel Lin <axel.lin@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-10-13 17:38:36 +01:00
Wolfram Sang
23524eb16a ASoC: tlv320aic32x4 fix initialization of micpga routing
Checking the pdata-flags used 'or', so the check is always true. Use 'and' to
correctly mask the flags.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Javier Martin <javier.martin@vista-silicon.com>
Cc: Liam Girdwood <lrg@ti.com>
Cc: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-10-06 20:00:11 +01:00
Mark Brown
20d660653a ASoC: Fix outdated API usage in tlv320aic32x4
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: Liam Girdwood <lrg@slimlogic.co.uk>
2011-03-07 11:13:42 +00:00
Javier Martin
1d471cd126 ASoC: Add TI tlv320aic32x4 codec support.
This patch adds support for tlv320aic3205 and tlv320aic3254 codecs.
It doesn't include miniDSP support for aic3254.

Signed-off-by: Javier Martin <javier.martin@vista-silicon.com>
Acked-by: Liam Girdwood <lrg@slimlogic.co.uk>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-03-04 18:21:08 +00:00