This stuff is all in the generic ia64 kernel, and the new initcall error
reporting complains about them.
Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Christoph Hellwig <hch@infradead.org> pointed that there are no
in-tree uses of this. So revert 9c65cb9be6
Signed-off-by: Tony Luck <tony.luck@intel.com>
The original ia64 udelay() was simple, but flawed for platforms without
synchronized ITCs: a preemption and migration to another CPU during the
while-loop likely resulted in too-early termination or very, very
lengthy looping.
The first fix (now in 2.6.15) broke the delay loop into smaller,
non-preemptible chunks, reenabling preemption between the chunks. This
fix is flawed in that the total udelay is computed to be the sum of just
the non-premptible while-loop pieces, i.e., not counting the time spent
in the interim preemptible periods. If an interrupt or a migration
occurs during one of these interim periods, then that time is invisible
and only serves to lengthen the effective udelay().
This new fix backs out the current flawed fix and returns to a simple
udelay(), fully preemptible and interruptible. It implements two simple
alternative udelay() routines: one a default generic version that uses
ia64_get_itc(), and the other an sn-specific version that uses that
platform's RTC.
Signed-off-by: John Hawkes <hawkes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Fix XPC so that it does not deliver any messages until the connected
callout has returned, as well as, prevent the disconnected callout to
occur before the disconnecting callout has returned.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The __sn_cnodeid_to_nasid array was incorrectly sized at MAX_NUMNODES.
On a large system, this array could overflow. The following patch
corrects this by defining it to MAX_COMPACT_NODES.
Signed-off-by: Dean Roe <roe@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This one falls into the "present for Andrew Morton" category to address
his wishlist for a compiler warning free build ;-)
Signed-off-by: Tony Luck <tony.luck@intel.com>
General SN2 code cleanup:
- Do not initialize global variables to zero
- Use kzalloc instead of kmalloc+memset
- Check kmalloc return values
- Do not obfuscate spin lock calls
- Remove some unused code
- Various formatting cleanups
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Remove an erroneous kfree, and unlink the pcidev_info struct from the
pcidev_info list prior to free'ing the pcidev_info struct.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Prevent SN2 specific code to be executed on non SN2 platforms when
running a generic kernel.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
There were two problems with enabling the PRINTK_TIME config
option:
1) The first calls to printk() occur before per-cpu data virtual
address is pinned into the TLB, so sched_clock() can fault.
2) sched_clock() is based on ar.itc, which may not be synchronized
across cpus.
Ken Chen started this patch, Tony Luck tinkered with it, and Jes
Sorensen perfected it.
Signed-off-by: Tony Luck <tony.luck@intel.com>
After converting the cpu physical address to shub2 physical
addressing, the address was run through TO_PHYS() which
clobbered a high node offset bit causing the BTE to fail
on shub2 nodes with large memory. This fix corrects
that problem.
Signed-off-by: Russ Anderson (rja@sgi.com)
Signed-off-by: Tony Luck <tony.luck@intel.com>
During some testing, we got a warning about trying to allocate
memory while holding a lock. This fixes that problem.
Signed-off-by: Robin Holt <holt@sgi.com>
Acked-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Maintenance patch:
- Add missing __init calls
- Do not zero initialize global variables
- No need to typecast function call returns to void
- Some formatting
Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Temporary patch to make pci_enable_msi() fail gracefully on altix. Will be
removed after 2.6.16 releases and the msi abstraction patches start flowing.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Redirecting interrupts using smp_affinity on altix does not work on kernels
built with CONFIG_PCI_MSI. The problem is that move_irq() turns into a noop
if MSI is built in. This patch calls move_native_irq() instead of move_irq()
to get around that.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch finishes support for SHUB2 (the new chipset). Most of the
changes are performance related. A few changes are workarounds for
"interesting" chipset features.
Some temporary debugging code has also been deleted.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
arch/ia64/sn/Makefile sets CPPFLAGS, expecting that setting to
propogate to all the subdirectories. For a normal build with its
recursive descent it does work, but doing a selective build like
'make arch/ia64/sn/kernel/io_init.i' does not do a recursive descent,
it goes directly to arch/ia64/sn/kernel/Makefile so the flags do not
get set.
To support selective builds, set the flags in all the subordinate Makefiles.
Signed-off-by: Keith Owens <kaos@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Remove the GFP_DMA flag from XPC kmalloc() calls.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Acked-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Takashi helped us track down a bad page state bug we thought was coming
from alsa. It turns out we weren't paying attention to the gfp flags
that were passed in to sn_dma_alloc_coherent().
From: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Greg Edwards <edwardsg@sgi.com>
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Jes Sorensen <jes@sgi.com>
Migrate sn2 code to use mutex and completion events rather than
semaphores.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Acked-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Bugfix... the altix SN_SAL_IOIF_SLOT_ENABLE & SN_SAL_IOIF_SLOT_DISABLE
SAL calls need to pass the segment# down
Signed-off-by: Mike Habeck <habeck@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Work-around to temporarily support older PROMs with new flush device code.
This code allows systems running older PROMs to continue to run on the new
kernel base until a new official PROM is released.
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Acked-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch separates the sn_flush_device_list struct into kernel and
common (both kernel and PROM accessible) structures. As it was, if the
size of a spinlock_t changed (due to additional CONFIG options, etc.) the
sal call which populated the sn_flush_device_list structs would erroneously
write data (and cause memory corruption and/or a panic).
This patch does the following:
1. Removes sn_flush_device_list and adds sn_flush_device_common and
sn_flush_device_kernel.
2. Adds a new SAL call to populate a sn_flush_device_common struct per
device, not per widget as previously done.
3. Correctly initializes each device's sn_flush_device_kernel spinlock_t
struct (before it was only doing each widget's first device).
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix (shub2) pushes the BTE clean-up into SAL.
This patch correctly interfaces with the now implemented SAL call.
It also fixes a bug when delaying clean-up to allow busy BTEs to
complete (or error out).
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Cleanup a few items after moving xpc.h from arch/ia64/sn/kernel to
include/asm-ia64/sn.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Move xpc.h from arch/ia64/sn/kernel to include/asm-ia64/sn without change.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Move xpc_system_reboot() to be closer to the file it calls for readability
reasons (which are indeed subjective).
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Allow for the loss of heartbeat while in kdebug to be ignored by remote
partitions.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Cleanup the XPC disengage related messages that are printed to the log.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch fixes a problem in XPC disengage processing whereby it was not
seeing the request to disengage from a remote partition, so the disengage
wasn't happening. The disengagement is suppose to transpire during the time
a XPC channel is disconnecting, and should be completed before the channel
is declared to be disconnected.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
arch: Use <linux/capability.h> where capable() is used.
Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
The first of these changes s/hotplug/uevent/ was needed to
compile sn2_defconfig (ia64/sn). The other three files
changed are blind changes of all remaining bus_type.hotplug
references I could find to bus_type.uevent.
This patch attempts to finish similar changes made in the
gregkh-driver-kill-hotplug-word-from-driver-core Nov 22 patch.
Signed-off-by: Paul Jackson <pj@sgi.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
I see why the problem exists only on SN. SN uses a different hardware
mechanism to purge TLB entries across nodes.
It looks like there is a bug in the SN TLB flushing code. During context switch,
kernel threads inherit the mm of the task that was previously running on the
cpu. This confuses the code in sn2_global_tlb_purge().
The result is a missed TLB purge for the task that owns the "borrowed" mm.
(I hit the problem running heavy stress where kswapd was purging code pages of
a user task that woke kswapd. The user task took a SIGILL fault trying to
execute code in the page that had been ripped out from underneath it).
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The patch that added support for a new platform chipset (shub2) broke
PTC deadlock recovery on older versions of the chipset. (PTCs are the
SN platform-specific method for doing a global TLB purge). This
patch fixes deadlock recovery so that it works on both the old & new
chipsets.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix only patch to add fixup code that sets up
pci_controller->window. This code is a temporary
fix until ACPI support on Altix is added.
Also, corrects the usage of pci_dev->sysdata,
which had previously been used to reference
platform specific device info, to now point to
a pci_controller struct.
Signed-off-by: John Keller <jpk@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The nasid_index was not being incremented if the
pointer was null, causing an infinite loop.
Signed-off-by: Russ Anderson (rja@sgi.com)
Signed-off-by: Tony Luck <tony.luck@intel.com>
The kernel's use of the for_each_*cpu(i) macros has allowed for sparse CPU
numbering. When I hacked the kernel to test sparse cpu_present_map[] and
cpu_possible_map[] cpumasks, I discovered one remaining spot, in
sn_hwperf_ioctl() during sn initialization, that needs to be fixed.
Signed-off-by: John Hawkes <hawkes@sgi.com>
Signed-off-by: Dean Roe <roe@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
