121 lines
3.4 KiB
C
121 lines
3.4 KiB
C
/*
|
|
* Platform data definitions.
|
|
*/
|
|
#ifndef __ASM_ARCH_BOARD_H
|
|
#define __ASM_ARCH_BOARD_H
|
|
|
|
#include <linux/types.h>
|
|
|
|
#define GPIO_PIN_NONE (-1)
|
|
|
|
/*
|
|
* Clock rates for various on-board oscillators. The number of entries
|
|
* in this array is chip-dependent.
|
|
*/
|
|
extern unsigned long at32_board_osc_rates[];
|
|
|
|
/* Add basic devices: system manager, interrupt controller, portmuxes, etc. */
|
|
void at32_add_system_devices(void);
|
|
|
|
#define ATMEL_MAX_UART 4
|
|
extern struct platform_device *atmel_default_console_device;
|
|
|
|
struct atmel_uart_data {
|
|
short use_dma_tx; /* use transmit DMA? */
|
|
short use_dma_rx; /* use receive DMA? */
|
|
void __iomem *regs; /* virtual base address, if any */
|
|
};
|
|
void at32_map_usart(unsigned int hw_id, unsigned int line);
|
|
struct platform_device *at32_add_device_usart(unsigned int id);
|
|
|
|
struct eth_platform_data {
|
|
u32 phy_mask;
|
|
u8 is_rmii;
|
|
};
|
|
struct platform_device *
|
|
at32_add_device_eth(unsigned int id, struct eth_platform_data *data);
|
|
|
|
struct spi_board_info;
|
|
struct platform_device *
|
|
at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n);
|
|
|
|
struct atmel_lcdfb_info;
|
|
struct platform_device *
|
|
at32_add_device_lcdc(unsigned int id, struct atmel_lcdfb_info *data,
|
|
unsigned long fbmem_start, unsigned long fbmem_len,
|
|
unsigned int pin_config);
|
|
|
|
struct usba_platform_data;
|
|
struct platform_device *
|
|
at32_add_device_usba(unsigned int id, struct usba_platform_data *data);
|
|
|
|
struct ide_platform_data {
|
|
u8 cs;
|
|
};
|
|
struct platform_device *
|
|
at32_add_device_ide(unsigned int id, unsigned int extint,
|
|
struct ide_platform_data *data);
|
|
|
|
/* mask says which PWM channels to mux */
|
|
struct platform_device *at32_add_device_pwm(u32 mask);
|
|
|
|
/* depending on what's hooked up, not all SSC pins will be used */
|
|
#define ATMEL_SSC_TK 0x01
|
|
#define ATMEL_SSC_TF 0x02
|
|
#define ATMEL_SSC_TD 0x04
|
|
#define ATMEL_SSC_TX (ATMEL_SSC_TK | ATMEL_SSC_TF | ATMEL_SSC_TD)
|
|
|
|
#define ATMEL_SSC_RK 0x10
|
|
#define ATMEL_SSC_RF 0x20
|
|
#define ATMEL_SSC_RD 0x40
|
|
#define ATMEL_SSC_RX (ATMEL_SSC_RK | ATMEL_SSC_RF | ATMEL_SSC_RD)
|
|
|
|
struct platform_device *
|
|
at32_add_device_ssc(unsigned int id, unsigned int flags);
|
|
|
|
struct i2c_board_info;
|
|
struct platform_device *at32_add_device_twi(unsigned int id,
|
|
struct i2c_board_info *b,
|
|
unsigned int n);
|
|
|
|
struct mci_platform_data;
|
|
struct platform_device *
|
|
at32_add_device_mci(unsigned int id, struct mci_platform_data *data);
|
|
|
|
struct ac97c_platform_data {
|
|
unsigned short dma_rx_periph_id;
|
|
unsigned short dma_tx_periph_id;
|
|
unsigned short dma_controller_id;
|
|
int reset_pin;
|
|
};
|
|
struct platform_device *
|
|
at32_add_device_ac97c(unsigned int id, struct ac97c_platform_data *data);
|
|
|
|
struct platform_device *at32_add_device_abdac(unsigned int id);
|
|
struct platform_device *at32_add_device_psif(unsigned int id);
|
|
|
|
struct cf_platform_data {
|
|
int detect_pin;
|
|
int reset_pin;
|
|
int vcc_pin;
|
|
int ready_pin;
|
|
u8 cs;
|
|
};
|
|
struct platform_device *
|
|
at32_add_device_cf(unsigned int id, unsigned int extint,
|
|
struct cf_platform_data *data);
|
|
|
|
/* NAND / SmartMedia */
|
|
struct atmel_nand_data {
|
|
int enable_pin; /* chip enable */
|
|
int det_pin; /* card detect */
|
|
int rdy_pin; /* ready/busy */
|
|
u8 ale; /* address line number connected to ALE */
|
|
u8 cle; /* address line number connected to CLE */
|
|
u8 bus_width_16; /* buswidth is 16 bit */
|
|
struct mtd_partition *(*partition_info)(int size, int *num_partitions);
|
|
};
|
|
struct platform_device *
|
|
at32_add_device_nand(unsigned int id, struct atmel_nand_data *data);
|
|
|
|
#endif /* __ASM_ARCH_BOARD_H */
|